MANNOL Protective Anticor

High quality anti-corrosion and anti-gravel agent in the form of a liquid based on synthetic resins and rubbers

It is intended for processing of external and internal surfaces of a car body, a bottom, wheel arches, wings, aprons, lower surfaces of thresholds of cars, etc

It is suitable for processing the internal surfaces of the hood, doors, and body amplifiers

For professional body repairs, it is used to protect welds from inside of panels, protect the internal surfaces of new body panels, as well as to process fenders, doors, aprons, hoods, trunks, etc. before installing on the car

Properties:

Reliably protects the body from the negative effects of road salt and deicing reagents, all types of atmospheric effects, corrosion, protects from scratches caused by road surface particles (gravel, crushed stone, etc.)

Has passivation properties, significantly slowing down the corrosion process that has already begun

Forms a strong, smooth, indelible elastic film with ticostropic properties (can be applied in a thick layer without forming smudges and self-leveling, and scratches on it are prone to self-tightening), resistant to mechanical influences, to moisture, salts, acids and alkalis after drying

Does not chip or wear during operation

Effectively penetrates into the smallest crevices, displacing water from cracks, crevices and joints between the body panels, forms a waterproof layer

Has excellent adhesion – holds securely even on smooth, non-porous surfaces

It does not lose its adhesive properties at extremely high temperatures – it does not peel off and is securely held on a heated surface

Neutral to metals, plastics, rubbers and paint coatings

Resistant to extremely low temperatures, retains plasticity and does not crack

It has sound-proof and anti-vibration properties, significantly reducing road noise and vibrations of body elements, thereby increasing the comfort of driving

Dry quickly

The declared properties are acquired after complete drying

Application: before applying the product, the surface must be thoroughly cleaned of rust, dirt and dust, grease, oil and other organic contaminants. For degreasing, we recommend using brake Cleaner

For best results, it is recommended to apply the product at room temperature

The product is applied using a spray gun with a compressor at a pressure of 2 to 8 bar (depending on the desired fineness of the spray)

Shake the balloon well before use. After pouring the product into the spray container, immediately close the balloon, as a film forms very quickly on the surface of the product

Spray with a layer of up to 1.5 mm at a distance of about 20-30 cm from the surface

Resistance to abrasion and corrosion increases with the thickness of the coating

For this reason, the spray process should be repeated once or twice after a short (1-2 minutes) drying time

To obtain a uniform coating and not to leave untreated areas, the spray must be carried out crosswise

The coating is not subject to further staining

Depending on the thickness of the layer and weather conditions, the car is ready to move again in about 2 hours

Final drying takes 12-24 hours